Using 100BaseT mode (half duplex)<br>
<UL>
<LI>Under SRM, <I>set ewa0_mode fast</I><BR>
</UL>

Using 100BaseTX mode (full duplex)
<UL>
<LI>Edit /etc/rc.config ; append "<I>speed 200</I>" after <B>IFCONFIG_n=</B> parameter.(where <b>n</b> is the network device number for tu<b>n</b>)<BR>
<LI>Under SRM, <I>set ewa0_mode auto</I>
</UL>


<H3>Benchmark: <BR></H3>
<B>File Server: </B>Linux 2.2.14 on Pentium II 400MHz, 256MB RAM, ASUS P2B board, LEMEL P-600TX Ethernet(21143),tulip driver v0.91g-ppc running 100BaseTX mode.<BR>
<B>Client 1: </B>Tru64 Unix V4.0F; Accton EN1207C-TX; running 100BaseT mode.<BR>
<B>Client 2: </B>Tru64 Unix V4.0F; Accton EN1207C-TX; running 100BaseTX mode.<BR>
<B>HUB: </B>Buffalo LSW10/100-8H 8 port switching hub with auto-nego and manual switch<BR>
<B>Target file: </B>linux-2.3.51.tar 83834880 bytes, using NcFTP 2.4.3 <BR><br>
<H4>Results</H4><PRE>
<B>100BaseT  Mode: </B> 7.99 MBytes/sec max with "get" command 
<B>                </B> 6.24 MBytes/sec max with "put" command
<B>100BaseTX Mode: </B>11.27 MBytes/sec max with "get" command
<B>                </B>10.89 MBytes/sec max with "put" command
</pre>